NETGEAR AXM762 - ProSafe 10 Gigabit Installation Manual

AXM762_IG_10July09.fm Page 1 Monday, July 13, 2009 12:23 PM
ProSafe 10 Gigabit Ethernet SFP+ Module AXM762 e

Install Your Optical Module

The 10 Gigabit small form-factor pluggable (SFP+) module provides a full-duplex 10G bps
each direction for Ethernet operation on NETGEAR managed switches.
The switch will automatically detect the AXM762, so you can simply plug it into an
available module slot.
The module can be inserted or removed while the switch is operational.
AXM762

Installing a AXM762 Module

Insert the module firmly into the slot that supports the SFP+ interface. Make sure the optical
cable you use is single mode LC to LC duplex cable.

Removing a AXM762 Module

Release the module latch by pulling down the handle bar across the module, and pull the
module out of the module slot.

Technical Specifications

Standards IEEE 802.3ae 10GBase-LR
Wavelength 1310nm
Dimensions (HxWxD) 0.46" x 0.53" x 2.19"
(11.9 mm x 13.7 mm x 55.7 mm)
Weight 19.2g
Operating Temperature 32 -158º F (0 - 70ºC)
Storage Temperature 32 -185 ºF (0 - 85ºC)
Operative relative humidity 85% @ (25ºC)
Operating Distance 2m - 10km for 9/125 um SMF
2 - 33 m for 62.5/125 um MMF
Connectors LC for 9um/125um single mode cable
Power Consumption <1.5w
MTBF 4,986,536 hr (569 years)
Safety Certification UL 1950 CSA 22.2 No. 950
Environmental Compliance -RoHS