Table of Contents
Advertisement
N300 Wireless Router Model JWNR2000Tv3
Router Setup Preparation
You can set up your router with the NETGEAR genie automatically, or you can use the genie
menus and screens to set up your router manually. Before you start the setup process, get
your ISP information and make sure the computers and devices in the network have the
settings described here.
Use Standard TCP/IP Properties for DHCP
If you set up your computer to use a static IP address, you must change the settings so that it
uses Dynamic Host Configuration Protocol (DHCP).
Gather ISP Information
If you have DSL broadband service, you might need the following information to set up your
router and to check that your Internet configuration is correct:
•
The ISP configuration information for your DSL account
•
ISP login name and password
•
Fixed or static IP address settings (special deployment by ISP; this situation is rare)
When your Internet service starts, your Internet service provider (ISP) typically gives you all
the information needed to connect to the Internet. If you cannot locate this information, ask
your ISP to provide it. When your Internet connection is working, you no longer need to
launch the ISP's login program on your computer to access the Internet. When you start an
Internet application, your router automatically logs you in.
Wireless Devices and Security Settings
Make sure that the wireless device or computer that you are using supports WPA or WPA2
wireless security, which is the wireless security that the router uses.
15
Advertisement
Table of Contents
