NETGEAR MR814 Installation Manual page 15

I cannot get onto the Internet with a computer
You may not have restarted the computer or the network to have TCP/IP changes take effect.
• Restart the computer.
• Unplug the router, and then restart the network. See Restarting the Network on page 9.
Your computer may not recognize any addresses.
• If you typed in addresses of one or two DNS servers when you configured the router,
restart your computer. Open the router's Settings pages and verify that the DNS addresses
appear. See instructions on page 10 to view the router's Basic Settings page.
Your computer may not have the correct TCP/IP settings to recognize the router.
• Restart the computer and check that you have TCP/IP set up properly on your computer.
For Windows, the Network Properties should have Obtain an IP address automatically
selected (see page 8). For Macintosh computers, the TCP/IP or Network control panel
should be set to Using DHCP Server (see page 9).
• You may also verify that the gateway address or the router's local IP address is 192.168.0.1.
The computer's IP address should be between 192.168.0.2 and 192.168.0.254.
Your router might not be able to obtain a IP address from the ISP.
1. Start your browser, type the address for an external site (like www.NETGEAR.com),
and press Enter (Windows) or Return (Macintosh).
2. Go to the router's Settings pages by going to http://192.168.0.1.
3. In the User ID box type admin, in the Password box type password, and click OK.
4. Under the Maintenance heading, click Router Status.
5. Check that an IP address is shown for the WAN Port.
If you see 0.0.0.0, contact your ISP to get current configuration information.
Your wireless connection settings may be incorrect.
• Verify the computer's Wireless Network Name (SSID) and Secure Encryption (WEP)
settings match the router's settings.
You may be out of range of the wireless broadcast.
• Try to move the computer closer to the wireless router.
14