Hitachi DH40MB Instruction Manual And Safety Instructions page 13

(1) Switching to "hammering"
(a) Pull the selector lever, release lock
and turn it counterclockwise.
(b) Align of the selector lever with
on the side of the undercover as
illustrated in Fig. 7.
(c) Push in the selector lever to lock it.
NOTE:
Turn the selector lever (do not pull it up)
to check if it is completely locked and
make sure that it does not turn.
(2) When fixing working positions of tools
such as cold chisel, etc.,
(a) Pull the selector lever, release lock
and turn it. Align
lever and
illustrated in Fig. 8.
(b) Push in the selector lever to lock it.
(c) Turn the grip as illustrated in Fig. 9
and fix the working position of the
tool.
(d) Switch the selector lever to
"hammring" according to the
procedures mentioned in the above
item (1) and secure the position of
the tool.
5. Install the stopper (Fig. 10)
(1) Loosen the side handle and insert the
straight portion of the stopper into the
handle bolt hole from the front cover.
(2) Loosen the side handle, move the
stopper to the specified position and
rotate the grip of the side handle
clockwise to fix the stopper.
of the selector
of the undercover as
Fig. 7
Fig. 8
Grip
Fig. 9
Stopper
Side Handle
Fig. 10
English
Undercover
Selector
Lever
Undercover
Selector
Lever
13