Central Pneumatic 46719 Owner's Manual page 11

Delayed or inadequate cleaning will permanently clog the Spray Gun.
pattern Adjustment
WARNING! Do not exceed the Maximum Air
pressure shown on the Specification chart.
10. Adjust the air supply pressure during
operation with the Trigger fully depressed
and the Air Knob fully open.
If reducing air pressure for specific areas,
use the Air Knob.
11. Use the Pattern Knob to
adjust the spray pattern.
Turn Pattern Knob counterclockwise
(all the way open) to flatten the spray pattern.
Turn it clockwise for a round spray pattern
- see Figure E: Pattern Adjustment.
Flat/
Open
Figure E: pattern Adjustment
Item 46719
NOTICE
Clean the Spray Gun IMMEDIATELY after use.
Round/
Closed
For technical questions, please call 1-800-444-3353.
Fluid Adjustment
12. Turn the Fluid Knob clockwise
until it is fully closed.
13. After setting up a piece of scrap
material, squeeze the Trigger in short
bursts while turning the Fluid Knob
counterclockwise to set the amount
of fluid - see Figure F: Fluid Adjustment.
Too Coarse Correct
(Increase
air flow)
Figure F: Fluid Adjustment
If spray is too fine:
Reduce the air pressure or allow more paint
to come out by opening the Fluid Knob.
If spray is too thick (globs of paint):
Close the Fluid Knob slowly,
checking the pattern after each adjustment.
Too Fine
(Decrease
air flow)
Page 11