Miele DA 1160 Operating And Installation Instructions page 25

^ Attach the hood to the wall anchors.
^ Tighten the two screws at the left and
the right on the back of the device.
These are used to adjust the tilt and
secure the hood in position.
^ Reinstall the overhead lights.
^ Put the grease filter back in place.
^ If extraction mode is used, install the
exhaust ducting and connections.
For air extraction mode:
^ For an C 6" (150 mm) exhaust duct,
use a pointed knife to cut off the
exhaust collar where it tapers.
For an C 5" (125 mm) exhaust duct,
use the collar as is.
^ If required, insert the non-return flap.
Ensure that the flap opens easily and
closes by itself.
Installation
25