Attach The Tv And Vcr To The Power Supply; Install Batteries In The Remote Control; Set The Rf Or Video Channel Switch - Hitachi VT-M181A Owner's Manual

Getting Started - 13 -
2. Using the 75 ohm cable supplied with your VCR, connect either end to the OUT TO
TV upper jack on the back of the VCR.
3. Use a second adapter to attach the other end of the 75 ohm connector back into the
TV (where you first disconnected the antenna).
Capabilities: With this hookup, you should now be able to perform all basic functions
provided by this equipment.

5 Attach the TV and VCR to the Power Supply

Plug in the TV and VCR power cords to the wall outlet or an appropriate extension cord
or surge protector. See Important Safeguards for further precautions (page 6).

6 Install Batteries in the Remote Control

The remote control requires two fresh "AA" batteries. On the back of the remote, a
plastic cover
slides off in the direction shown by the arrow. Remove this cover and install the
batteries, matching the plus end of each battery with the plus mark on the remote.

7 Set the RF or Video Channel Switch

When the VCR is on, its video signal can come into your TV on either channel 3 or
channel 4. You need to select the appropriate channel.
Turn the power on to both the TV and the VCR, and look for a switch on the back of
the VCR. Set the switch to 3 or 4, whichever is not a commercial channel in your area.
Your basic hookup is now complete. When you're ready to try hooking up a second
VCR or a video camera for a complete home entertainment system, see Advanced
Operations.
Now turn the TV and VCR back around facing you and begin your quick tour of the
controls (page 14).