Panel And Microphone Connection; Panel And Microphone Connection Using Pg-4Z (Option) - Kenwood TS-480HX Instruction Manual

1 INSTALLATION

PANEL AND MICROPHONE CONNECTION

Plug the microphone plug to the MIC jack (8-wire/ RJ45), then connect the Remote Control panel to the TX/ RX
unit with the supplied cable (2 m/ 6-wire/ RJ11).

PANEL AND MICROPHONE CONNECTION USING PG-4Z (OPTION)

Use the cables and connectors to connect the Remote Control panel and TX/ RX unit with the PG-4Z cable kit as
shown below.
Extension adaptor (RJ45)
from the PG-4Z cable kit
Line filter (large) from
the PG-4Z cable kit
Line filter (small) from
the TS-480
Tapping screw
(4 mm x 14 mm)
Flat washer
Cable
holder
RJ45 (8-wire)
adaptor
Double-sided
adhesive tape
6
Microphone
To MIC
m
3 c
3 c
c m
3
c m
1
Line filter (small) from
the PG-4Z cable kit
Microphone cable
To PANEL
Line filter
Extension cable (RJ45)
from the PG-4Z cable kit
To MIC
m
To EXT.SP
Extension cable (RJ11)
from the PG-4Z cable kit
To external speaker
External speaker extension
cable from the PG-4Z cable
kit (when the external speaker
is used)
Extension adaptor (RJ11)
from the PG-4Z cable kit