Displacement Pump - Graco 220-856 Instructions And Parts List

52
A
51
50
6
76
75
74
Torque to
80 ft–lb (107 N.m)
Fig. 14
WARNING
INJECTION HAZARD
To reduce the risk of serious bodily
injury, follow the Pressure Relief Proce-
dure Warning on page 11 before check-
ing or repairing any part of the spray system.
Removing the pump
1. Flush the sprayer. Relieve pressure.
2. Remove the clips (74,76) and drain hose (75).
3. Hold the intake valve (222) steady with a wrench
and unscrew the suction tube (3).
4. Use a screwdriver to push the retaining spring (49)
up, and then push out the pin (50).
5. Loosen the locknut (6). Unscrew the pump (4).

Displacement Pump

49
223
30
32
4
222
3
01746B
See Fig. 14.
Repairing the pump
See manual 307–806 for pump repair instructions.
Reinstalling the pump
1. Rotate the crankshaft (A) so the connecting rod is
in its lowest position.
2. The pump piston rod (223) should protrude about
1 in. (25 mm) above the pump cylinder.
3. Screw the pump into the bearing housing (51) until
its pin hole is aligned with the connecting rod (52)
pin hole. Insert the pin (50). Position the spring
(49) so it covers the ends of the pin. See Fig. 15.
WARNING
Be sure the retaining spring (49) is firmly and com-
pletely in the groove of the connecting rod to prevent
the pin (50) from working loose due to vibration.
If the pin works loose, it or other parts could break off
due to the force of the pumping action, resulting in
serious bodily injury, pump or property damage.
4. Adjust the pump so the cylinder's top threads are
flush with the face (B) of the bearing housing and
the outlet nipple (32) is straight back. See Fig. 15.
5. Torque the locknut (6) to 80 ft-lb (107 N.m).
6. Reassemble the remaining parts, in the reverse
order of removal.
50
49
B
Fig. 15
See Fig. 14 and 15.
52
51
32
01751A