Table of Contents
Advertisement
3-3
Integrated Peripherals
CMOS Setup Utility-Copyright (C) 1984-2006 Award Software
On-Chip Primary PCI IDE
On-Chip SATA Mode
x PATA IDE Set to
SATA Port 0/2 Set to
USB Controller
USB 2.0 Controller
Legacy USB storage detect
Onboard Serial Port 1
Onboard Serial Port 2
: Move
Enter: Select
F5: Previous Values
On-Chip Primary PCI IDE
Enabled
Disabled
On-Chip SATA Mode
Disabled
Auto
Combined
Enhanced
Non-Combined
PATA IDE Set to
Ch.0 Master/Slave Set PATA IDE to Ch. 0 Master/Slave. (Default setting)
Ch.1 Master/Slave Set PATA IDE to Ch. 1 Master/Slave.
SATA Port 0/2 Set to
This value will auto make by the setting "On-Chip SATA Mode" and "PATA IDE Set to".
If PATA IDE were set to Ch. 1 Master/Slave, this function will auto set to Ch. 0 Master/Slave.
USB Controller
Enabled
Disabled
USB 2.0 Controller
You can disable this function if you are not using onboard USB 2.0 feature.
Enabled
Enable USB 2.0 controller. (Default setting)
Integrated Peripherals
[Enabled]
[Auto]
Ch.0 Master/Slave
Ch.2 Master/Slave
[Enabled]
[Enabled]
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Enable onboard 1st channel IDE port. (Default setting)
Disable onboard 1st channel IDE port.
Disable this function.
BIOS will auto detect. (Default setting)
Set On-Chip SATA mode to Combined, you can use up to 4 HDDs on
the motherboard; 2 for SATA and the other for PATA.
Set On-Chip SATA mode to Enhanced, the motherboard allows up to 6 HDDs
to use; 4 for SATA and the other for PATA.
Set On-Chip SATA mode to Non-Combined, SATA will be simulated to
PATA mode. Support a maximum of 4 SATA devices. PATA devices will be
ignored.
Enable USB controller. (Default setting)
Disable USB controller.
30
Item Help
Menu Level
F10: Save
ESC: Exit
F7: Optimized Defaults
BIOS Setup
F1: General Help
Advertisement
Table of Contents
