Antenna Connections; Cable Tv Connections - Hitachi LCD HDTV LE19S304 Owner's Manual

Antenna connections

If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna system. If you
are using a Cable TV service, see Cable TV connections.
Combination VHF/UHF Antenna (Single 75 ohm cable)
Antenna
Jack
75 ohm
Coaxial
Cable

Cable TV connections

This TV has an extended tuning range and can tune most cable channels without using a Cable TV Converter box. Some
cable companies offer "premium pay channels" where the signal is scrambled. Descrambling these signals for normal
viewing requires the use of a descrambler device which is generally provided by the Cable TV company.
For subscribers to basic Cable TV service
75 ohm
Coaxial Cable
For subscribers to scrambled Cable TV service
If you subscribe to a Cable TV service which requires the use of a Converter/Descrambler box, connect the incoming 75 ohm Coaxial
Cable to the Converter/Descrambler box. Using another 75 ohm Coaxial Cable, connect the output jack of the Converter/Descrambler
box to the Antenna Jack on the TV. Follow the connections shown below. Set the TV to the output channel of the Converter/Descrambler
box (usually channel 3 or 4) and use the Converter/Descrambler box to select channels.
Incoming 75 ohm Cable TV Cable
For subscribers to unscrambled Cable TV service with scrambled premium channels
If you subscribe to a Cable TV service in which basic channels are unscrambled and premium channels require the use of a Converter/
Descrambler box, you may wish to use a signal Splitter and an A/B Switch box (available from the Cable TV company or an electronics
supply store). Follow the connections shown below. With the switch in the "B" position, you can directly tune any nonscrambled channels
on your TV. With the switch in the "A" position, tune your TV to the output of the Converter/Descrambler box (usually channel 3 or 4) and
use the Converter/Descrambler box to tune scrambled channels.
Incoming
75 ohm
Cable TV
Cable
The nationwide switch to digital television broadcasting will be complete on June 12, 2009, but your local television stations may switch sooner. After
the switch, analog-only television sets that receive TV programming through an antenna will need a converter box to continue to receive over-the-air
TV. Watch your local stations to find out when they will turn off their analog signal and switch to digital-only broadcasting.
Information about the DTV transition is available from your local television stations, www.DTV.gov, or 1-888-CALL-FCC (TTY 1-888-TELL-FCC), and
www.dtv2009. gov or 1-888-DTV-2009 (TTY 1-877-530-2634) for information about subsidized coupons for digital-to-analog converter boxes.
Please review this Operating Guide for further information regarding such connections.
Hitachi supports the DTV transition and as a member of the DTV Transition Coalition urges consumers to visit these web sites for interactive guides
and further detailed information:
• www.dtvtransition.org
• www.myceknowhow.com
• www.dtv2009.gov
12
3AQ0221B_eng.indd 12 3AQ0221B_eng.indd 12
Connect the 75 ohm cable from the combination VHF/UHF antenna to the antenna jack.
For basic Cable TV service not requiring a Converter/Descrambler box, connect the
75 ohm Coaxial Cable directly to the Antenna Jack on the back of the TV.
Antenna
Jack
Converter/
Descrambler
Converter/
Descrambler
A/B Switch
Splitter
IMPORTANT NOTICE
Antenna
75 ohm Cable to TV
Antenna
75 ohm Cable to TV
A
B
Jack
Jack
7/15/10 9:22:00 AM 7/15/10 9:22:00 AM