Cable And Miscellaneous - Honeywell VideoBloX Quick Start Manual

Equipment Required

Cable and Miscellaneous

Rev 1.0
• Coaxial cables from Cameras to Video Input Module.
• Coaxial cables from Monitors to Video Output Module.
• Power cable from cameras to 24VAC Power Supply
• RS232 Cable - from COM port on PC to VideoBloX CPU (9-pin Female connector to
9-pin Female connector, included)
• Build an RS232 cable with fly leads on one end and a male DB9 connector on the
other end. This cable is for connection between the HEGS5BLX terminal block and
the female DB9 on the RS232/RS422 converter
• Modify one of the supplied RS422 cables with male DB9 connectors on both ends to
fly-leads on one end and male DB9 connector on the other end. Cut one of the DB9
connectors off and strip the wires back 1/4". This cable is connected between the
terminal strip on the RS232/RS422 converter terminal strip and the VideoBloX CPU
RS422 master female DB9 connector.
• Flat 6x6 cable (supplied with the HEGS5BLX) for connection between the HEGS5BLX
and the terminal block (supplied with the HEGS5BLX).
• Special Cable from the PIT to the Dome. The output from the PIT is RS422. Build a
2-wire cable lead using CAT5 or similar type. Solder the wires to pin 1 and 2 of a 9-Pin
Male D-plug. Connect the plug to the PIT and the end of the wires to the DATA inputs
of the dome.
• Standard PC Power cable (IEC)
Note All coaxial cable must have a nominal impedance of 75 ohms.
The RS422 cable should be 8-core twisted-pair with a shunt
capacitance of 16 pF/ft (CAT5).
4 Document 900.0840
09/06