Table of Contents
Advertisement
H
IMPORTANT! Use only a Power Wheels
(4.0 Amp/Hr.) battery with a Power Wheels
installed. Use of any other battery or fuse will damage
your vehicle. Make sure that you charge the battery for
at least 18 hours using the enclosed Power Wheels 6 Volt
(4.0 Amp/Hr.) charger before operating your vehicle for
the first time. Charge the battery for at least 14 hours after
each use of the vehicle. Never charge the battery longer
than 30 hours. Failure to follow these instructions may dam-
age your battery and will void your warranty.
1
Seat
Lock Fastener
LOCKED
• To unlock the lock fastener, use a slotted screwdriver
to rotate the lock fastener
position
.
• Lift the seat to remove it from the vehicle frame.
Battery Installation
®
6 Volt
®
25 Amp fuse
Lock Fastener
Lock Fastener
UNLOCKED
1
/
turn to the unlocked
4
2
Battery Clamp
• Place the Power Wheels
upright in the battery compartment. Make sure the
battery connector extends toward the rear of the vehicle.
• Make sure a Power Wheels
condition, is installed in the battery.
• Fit one end of the battery clamp into the hole in the
vehicle frame.
• Insert the #8-18 x
battery clamp and into the vehicle body. Tighten the
screw with a Phillips screwdriver. Do not over-tighten.
3
IMPORTANT! There are three electrical connections to be
made on this product. All three electrical connections must
be made in order for your product to function properly.
Please follow these instructions carefully.
• Fit the battery connector into the motor harness
connector. This is the third and last electrical connection.
Notes:
- If the battery connector will not plug into the motor
harness connector, turn it over and try again! Do not force
the battery connector into the motor harness connector.
- If the bubble blower immediately starts, you have not
made all the electrical connections properly. Unplug the
motor harness connector from the battery connector. This
will turn off the bubble blower. Now, review Assembly step
11 (page 10) and Assembly step 20 (page 12) to properly
make all electrical connections.
• Re-assemble the seat to the vehicle frame.
(See assembly step 21 on page 13.)
IMPORTANT! Always remember to keep the lock fastener
locked at all times to prevent children from accessing
the battery.
15
®
6 Volt (4.0 Amp/Hr.) battery
25 amp fuse, in good
®
7
/
" screw through the end of the
8
Battery
Connector
Motor Harness
Connector
Advertisement
Table of Contents
