Accessories; Remote Control Battery Installation And Replacement; First Time Use - Hitachi 37HLX99 Operating Manual

Accessories

Check to make sure you have the following accessories before disposing of the packing material.
³
Remote Control
+
-
/
For U.S. models:
For optional accessories, please access our web site at:
www.hitachi.us/tv
CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not
2. This stand for use only with Hitachi 37HLX99. Use with other
³ Remote Control Unit CLU-3861WL
(Part No. HL02069).
· Two "AA" size, 1.5V batteries (P# FQ00021).
» Power Cord (P# EV01841).
¿ Table Top Stand (P# QJ02673 ).
REMOTE CONTROL BATTERY INSTALLATION
AND REPLACEMENT
1. Open the battery cover of the remote control by
pushing down and sliding the back cover off.
2. Insert two new "AA"
remote control.
When replacing old batteries, push them
towards the springs and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery compartment.
4. Replace the cover.
CAUTION: Do not insert batteries with the '+'and '-' polarities reversed as this may cause the
batteries to swell or rupture resulting in leakage.
4
»
·
Two "AA" size,
1.5V batteries
¿
Table Top Stand
´
provide adequate ventilation for the electronics or proper support for the front glass
panel. This LCD television product is designed for a maximum tilting angle of 45
degrees from vertical.
apparatus is capable of resulting in instability causing possible injury.
size batteries for the
²
Power Cord
¶
2 IR Blaster Cables
Note: Please visit our
website for optional
accessories.
´ Two IR Blaster cables (P# EY01641).
² Power Swivel Cable (P# EW08432).
¶ 1 Ferrite Core (P#2169513).
BOTTOM VIEW
(Remote Control)
Press down and slide back to remove.
Power Swivel Cable
1 Ferrite Core
(see page 14)