Power Light Indicator; Remote Control Sensor; Ir Out Sensor; Photo Input - Hitachi 37HLX99 Operating Manual

Front/Side Panel Controls

POWER light indicator

To turn the TV ON, press the main power
switch located on the lower right side of the
TV. A red stand-by indicator lamp located on
the lower right of the front bezel will
illuminate. The LCD TV is now ready for
remote ON/OFF operation.
Indicating Lamp Power Status
Lamp 1 Lamp 2
Off
Off
Lights
Off
Red
Blinking
Off
Blue
(Turning ON )
Lights
Off
Blue
Lights
Off
Orange
(Power Saving)

REMOTE CONTROL sensor

Point your remote at this area when selecting
channels, adjusting volume, etc.

IR OUT sensor

Point your equipment's remote control at this area.
The IR will pass through the IR Blaster cables
to your equipment.
SIDE INPUT JACKS (for INPUT:5)
INPUT 5 provide Y-PBPR jacks for
connecting equipment with this capability, such as
a DVD player or Set Top Box. You may use
composite video signal for this input.
NOTE: 1.
Your component outputs may be labeled
Y, B-Y, and R-Y. In this case, connect the
components B-Y output to the TV's P
input and the components R-Y output to
the TV's P input.
R
2. Your component outputs may be labeled
Y-C C . In this case, connect the component
B R
C output to the TV's P
B
component C output to the TV's P
R
It may be necessary to adjust TINT to
3.
obtain optimum picture quality when using
inputs (see page 43).
the Y-P P
B R
INPUT 3, INPUT 4 and INPUT 5 (Y/VIDEO) can
4.
be used for composite video and component
video input.
NOTES: 1. Your HITACHI LCD TV will appear to be turned OFF (lights orange) if there is no video input
when INPUT : 1, 2, 3, 4 and 5. Check the Power Light condition to make sure the TV is
turned off or in Stand-by mode (lights red) when not in use.
2. Remote Control can not turn ON/OFF the "MAIN POWER" of the TV.
Operating
OFF. When the main power switch is set to Off.
When the main power switch on the TV
OFF.
(Stand-by) is ON.
OFF.
TV MAIN POWER is ON ; but no picture is shown.
O n
TV MAIN POWER is ON ; picture is shown.
Off TV MAIN POWER is ON with no signal input
except antenna (no sync. signal).
B
input and the
B
input.
R

PHOTO INPUT

Insert USB cable from your Digital Camera, USB
memory or memory card USB drive to view your
digital still pictures (see page 27).
Lamp 2
Lamp 1
IR S ensor
11