Table of Contents
Advertisement
HOW TO SETUP YOUR NEW HITACHI PLASMA TELEVISION
To take measures to prevent the Plasma Display from tipping over and prevent possible injury it is important to mount the unit
in a stable place.
Securing to a table-top
1.
Using wood screws (two) fasten the set to the clamping screw holes on the rear of the Plasma Display stand as shown below.
2.
Using commercially available wood screws, secure the set firmly in position.
32"
Securing to a wall
1.
Keep the Plasma Display monitor four inches away from the
wall except those hung to the wall mount bracket.
2.
Secure the monitor to the wall as shown below.
10cm (4 inches) or more
Wood Screw
Wire
NOTES:
1.
Do not block the ventilation holes of the Plasma Display monitor or the AVC center. Blocking the ventilation holes might cause fire
or defect.
2. The plasma television has two AC cords, one on the AVC center and the other on the Plasma Display monitor. In case of an
abnormal symptom, unplug both AC cords.
3. If you purchased the wall mount bracket option, please ask for professional installer. Do not install by yourself.
Caution when moving the main unit
As this product is heavy, whenever it is moved, two people are required to transport it safely. Whenever the unit is moved it should be
lifted forward using the two handgrips at the back for the 42", and at the top and base on both sides of the 32" and 50" for stability. When
moving the Display Monitor, lift the handles and the bottom frame as shown below. Do not grab the speakers or the back cover when
lifting.
32"
32"
ANTENNA
Unless your Plasma Television is connected to a cable TV system or to a centralized antenna system, a good outdoor color TV antenna
is recommended for best performance. However, if you are located in an exceptionally good signal area that is free from interference
and multiple image ghosts, an indoor antenna may be sufficient.
LOCATION
Select an area where sunlight or bright indoor illumination will not fall directly on the picture screen. Also, be sure that the location
selected allows a free flow of air to and from the perforated back cover of the set.
To avoid cabinet warping, cabinet color changes, and increased chance of set failure, do not place the TV where temperatures can
become excessively hot, for example, in direct sunlight or near a heating appliance, etc.
Wood screw
two places
Stabilization bolts
(Provided)
String or Wire
50"
Handgrips
Wood screw
two places
42"
AVC Vertical Position (Using AVC Stand)
1.
2.
32"
42"
42"
42"
6
50"
Install AVC Stand with screws provided.
AVC ventilation holes should be facing out.
AUDIO VIDEO CONTROL CENTER
VOL-
VOL+
CH-
CH+
INPUT/EXIT
POWER
STANDBY (RED) ON (GREEN)
50"
PULL
Advertisement
Table of Contents
