Beko TF546APW Installation, Operating And Maintanance Instructions page 10

3. Gently prise off plastic hinge covers
on both sides of front top panel using
a small flat-headed screwdriver. (1-2)
4. Unscrew the bolts of the top hinge
and remove top hinge. (3)
5. Remove door carefully off the
bottom hinge and stand door upright
in a safe place.(4)
6. Gently prise off plastic hinge cover
on door top trim. Fit the other door top
trim plastic off hinge cover supplied in
the plastic bag.(5)
7. Gently tilt the appliance back
against a strong wall on its rear side
sufficiently to allow the lower hinge
to be removed. Take care to protect
the appliance, your wall and floor
coverings. You can utilise the original
packaging to do this.Once you tilt the
appliance back, check to make sure
the appliance is completely stable and
safe before you carry on. (6)
8.Unscrew and remove the front feet
and 1 bolt. (7)
9. Unscrew and remove the bottom
hinge. (8)
10. Unscrew and remove the bottom
hinge door stopper and bushing and
reposition them on the other side while
rotating the bushing 180°. (9)
11. Fit the bottom hinge and tighten
the screws as shown in figure. (10)
12. Fit the other front feet as shown in
figure. (11)
13. Rotate the top hinge 180°.
Unscrew the hinge pin and re-tighten it
to the opposite side. (12)
14. Fit the top hinge on the left hand
side bushing of the door. (13)
15. Locate and re-fit door to bottom
hinge pin. (14)
16
. Re-fit the upper hinge on the opposite side
by using a flat headed screwdriver. (15)
17. Fit front top panel plastic hinge
covers on the opposite sides. (16)
18. Remove the handle cover gently
taking care not to damage the
appliance.(17)
19. Rotate 180 degrees and fit handle
to the other side after removing hole
plugs gently.(19)
20. Adjust the two front feet if
necessary.
21. Check that door opens and closes
easily, it is aligned correctly and there
are no gaps allowing air into the
cabinet. If here are gaps between the
door seal and the cabinet, adjust the
door seal by gently pulling away from
the door using fingers.
22. Check that all the hinge screws are
tightened. Avoid over tightening the
screws.
23. Put all items, fittings back in the
appliance.
24. Wait for at least 4 hours to allow
the system to settle before switching
on.
25. Once the correct storage
temperatures have been reached in
the appliance, put back all the food.
9
EN