Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Cadence CEQ-783
Summary of Contents for Cadence CEQ-783
- Page 1 CeQ-783 PREAMP PARAGRAPHIC EQUALIZER // OWNERS MANUAL...
- Page 3 The purpose of the 4 paragraphic frequency bands built into the CEQ-783 is to allow you to tune the basic frequencies in order to correct problems in car responses. Once brought into focus, the problem frequency can then be attenuated or boosted. Precise control is therefore possible over the entire frequency range.
-
Page 4: Specifications
SPECIFICATIONS Paragraphic Equalizer Frequencies Band One Center: 50Hz Band Two Center: 200Hz Band Three Center: 1KHz Band Four Center: 20KHz Equalization Control: Boost/Cut 18dB Frequency Response: 30Hz - 250Hz Total Harmonic Dist.: <0.05% Signal to Noise Ratio: >95dB Maximum Output Level: 9 Volts RMS Dimensions: 7”... -
Page 5: Installation & Wiring
Use a BLACK colored wire to connect the CEQ-783 GROUND terminal directly to the vehicles chassis. The RED colored wire with the in-line fuse is for the main power to the CEQ-783. It should be connected to a 12V+ source. This is normally the same power source which your head unit is connected to. - Page 6 LINE DRIVER: The CEQ-783 has a built-in DC to DC fully isolated power supply and is capable of producing up to 9 volts of audio output through the RCA preamp connections. The Line Driver feature will guarantee a strong audio signal to the amps and ensure clean distortion free audio reproduction.
-
Page 7: Controls, Indicators, And Terminals
CONTROLS, INDICATORS, and TERMINALS SYSTEM VOLUME MATCHING CONTROL and USB/SD TRACK CONTROL GAIN FREQUENCY SD CARD READER BACKLIT LCD SCREEN FADER MP3 PLAYER ON/OFF VOLUME VOLUME FADER GAIN FREQ PLAYER -18dB +18dB -18dB +18dB -18dB +18dB -18dB +18dB 30Hz 250Hz 50Hz 200Hz 1KHz... - Page 8 Equalizer Frequency Control: The CEQ-783 allows you to boost or cut up to 18dB the following center control frequencies: 50Hz, 200Hz, 1KHz, 20KH. Source Selector: Use the Player button to select between the SD card reader, USB input, or the Mini-jack MP3 input (Aux jack). Push in the CD se- lector button to listen to CD source or out to listen to MP3 source.
-
Page 9: Wiring Diagrams
WIRING DIAGRAMS MEMORY STICK SD CARD SIGNAL SOURCE SIGNAL SOURCE TRK 1 The Cramps Garbage man 00:00 03:30 MP3/AUX SIGNAL SOURCE STEREO LOUD CD TRACK 01 MAIN SIGNAL SOURCE SUBWOOFER REAR SPEAKERS FRONT SPEAKERS... - Page 10 MEMORY STICK SD CARD SIGNAL SOURCE SIGNAL SOURCE TRK 1 The Cramps Garbage man 00:00 03:30 MP3/AUX SIGNAL SOURCE STEREO LOUD CD TRACK 01 MAIN SIGNAL SOURCE SUBWOOFER REAR SPEAKERS FRONT SPEAKERS...
- Page 11 MEMORY STICK SD CARD SIGNAL SOURCE SIGNAL SOURCE TRK 1 The Cramps Garbage man 00:00 03:30 MP3/AUX SIGNAL SOURCE STEREO LOUD CD TRACK 01 MAIN SIGNAL SOURCE SUBWOOFER REAR SPEAKERS FRONT SPEAKERS...
-
Page 12: Final System Check
7. Restart the system and increase the volume of the CEQ-783 to your desired listening pleasure. 8. The CEQ-783 should be able to run the system even with the amplifier gains set to minimum. If you can not reach your desired listening level you may raise the amplifier gains. - Page 14 // Features and specifications subject to change and or improvement without notice. Though we tried our best to ensure that this manual is free and clear of errors please don’t hold us responsible for printing errors. // www.cadencesound.com...