Download Print this page

Final System Check - Cadence CEQ-777 Owner's Manual

4 band parametric equalizer

Advertisement

FINAL SYSTEM CHECK

Begin with the radio in the off position. Set the fader and all the controls to their center positions. Switch your car ignition or ac-
cessory on and turn the radio volume down. The illumination around the knobs should now be lit. If nothing happens check for
proper power, ground, and that the fuse is not blown. If all connections have been verified correct, check that the remote wire is
actually getting power.
To the do-it-yourselfer, if you are sure of all your connections and the unit still does not operate properly, we request that you seek
qualified help to verify that the installation was done properly before exchanging or sending back the unit for repair.
If your system turned on, slowly raise the volume of the CEQ-777 – the volume should increase from all your speakers. Rotate your
radio balance in conjunction with the CEQ-777 fader to make sure that the sound is moving correctly from left to right and front to
rear. It is important that your radio fader and balance be left in their center positions.
Adjusting the System:
Once you are certain that all the wiring is correct and that the unit turns properly you are ready to adjust the audio section.
1. Disconnect the amplifiers remote turn on leads.
2. Adjust all the amplifier gains to minimum.
3. Turn the master volume of the CEQ-777 to maximum.
4. Turn the volume of your head unit to maximum and then down a drop.
5. Switch on any secondary sound source you may have hooked into the MAIN/AUX inputs of the CEQ-777. Now
adjust the input level controls found on the top of the unit chassis.
6. Reduce the master volume of the CEQ-777 and reconnect the remote turn on leads to the amplifiers.
7. Restart the system and increase the volume of the CEQ-777 to your desired listening pleasure.
8. The CEQ-777 should be able to run the system even with the amplifier gains set to minimum. If you can not reach your
desired listening level you may raise the amplifier gains. Setting amplifier gains unnecessarily to maximum can cause
cause noise problems in your system.
11

Advertisement

loading