NTRODUCTION Thank you for purchasing the 2-Port USB 3.0 SuperSpeed PCI Express Card. The 2-Port USB 3.0 SuperSpeed PCI Express Card adds SuperSpeed USB capabilities to your computer. Simply install this card into an available PCI slot on your computer to add two USB 3.0 SuperSpeed ports. SuperSpeed USB supports transfer rates of up to 5 Gbps- up to 10 times faster than USB 2.0.
EATURES Adds two USB 3.0 A-Male ports to a computer Connects internally via the PCI-e connector 5 Gbps signaling rate- 10X faster than USB 2.0 Backwards compatible with USB 2.0 Improved power efficiency over USB 2.0 Ideal for large data transfers from external hard drives, real-time video cameras, and other data intensive devices...
RIVER NSTALLATION Before you install the device in your computer, you will need to install the necessary driver for proper operation. Please follow the procedure below. For Windows XP, Vista, Windows 7 Note: The following setup is an example shown using a Windows XP operating system. Some screenshots may vary slightly depending on your operating system.
Page 9
RIVER NSTALLATION Step 2 After reading the End-User License Agreement, please select “I accept the terms in the License Agreement” and click Next. Step 3 Please click Browse to choose the destination folder, and then click Next.
Page 10
RIVER NSTALLATION Step 4 Click Install to begin driver installation. The driver installation may take a few minutes. You may also get a software installation Windows security pop-up during this time. Click Continue Anyway when it appears to complete the installation.
Page 11
RIVER NSTALLATION Step 5 When the installation has completed, click Finish to exit the setup wizard.
EVICE NSTALLATION Step 1 Turn off your computer and remove the cover/panel to expose the PCI slot. Step 2 Plug the 2-Port USB 3.0 Card into the PCI slot on the computer. Step 3 Replace the cover/panel and turn on your computer. When your computer starts up, a Found New Hardware Wizard will appear.
Page 13
EVICE NSTALLATION Step 4 When the Found New Hardware Wizard appears, select Yes, this time only, and click Next. Step 5 Choose Install the software automatically and click Next. The Windows security pop-up may appear during this process. Click Continue Anyway to continue with the installation.
Page 14
EVICE NSTALLATION Step 6 Click Finish to complete the installation and exit the wizard. Step 7 The Found New Hardware Wizard will appear again. Repeat steps 4-6 for second USB 3.0 port installation.
ERIFY EVICE NSTALLATION After you have completed the driver and device installation, you can go to the Device Manager to verify the product is installed and recognized properly. Windows XP Windows Vista/Windows 7...
ECHNICAL PECIFICATIONS Product No. 29055 Complies USB Rev. Ver. 3.0 Revision 2.0; PCI Bus Power PCI Express Base Management Interface Specification Specification: Revision Connectors USB 3.0 Type A x2 (Downstream) Low-speed (1.5Mbps)/ Full-speed (12Mbps)/ Data Speed Support High-speed (480Mbps)/ Super-...
ABLES ARRANTY At Cables To Go, we want you to be totally confident in your purchase. That is why we offer a one year warranty on this device. If you experience problems due to workmanship or material defect for the duration of this warranty, we will repair or replace this device.
EGULATORY OMPLIANCE FCC Conditions This equipment has been tested and found to comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) This device must accept any interference received. Including interference that may cause undesired operation.
Page 21
For more information on this product or to check for updated drivers, manuals or frequently asked questions please visit our website. www.cablestogo.com . 1.0.4.16.10...