Using Your Ice Shaver; Cleaning Your Ice Shaver; Helpful Hints - JELLY BELLY ICE SHAVER Instruction Manual

1. Fill a standard ice cube tray or the supplied ice cups with water and freeze. Ice
cubes work well in the Ice Shaver but may produce a slightly coarser textured
ice than the ice cup block.
2. Place the shaver bowl on top of the base, aligning the tabs with the slots and
gently press down until the shaver bowl locks into place. Place the collar on top
of the base, align the tab with the crosspiece with the slot at the back
of the shaver and gently press down until the collar locks into place.
To remove, squeeze all 4 tabs and lift.
3. Turn the blade adjustment knob on the side of the base - clockwise (right) for
finer and counterclockwise (left) for coarser shaved ice. Note: Do not change
the knob position while shaving ice.
4. Place prepared ice in the shaver.
5. To use paper or silicone cone cups, pivot the cone cup holder forward under the
shaving blade, or place a bowl or ice cup on the base to collect the shaved ice.
Note: Pivot the cup holder to the back if using a bowl or ice cup.
6. Place the shaver motor on top of the ice, plug into an electrical outlet, and press
the power button while applying a steady, downward pressure. The motor will
start and ice shaving will begin. To stop shaving, remove hand from power
button.
7. Add your favorite Jelly Belly™ premium syrup, soft drink, or fresh fruit to the
shaved ice and enjoy.
8. Unplug from the power supply immediately after use.
•
A small amount of smoke and/or odor may occur upon use due to the
release of manufacturing oils - this is normal.
•
Some minor expansion/contraction sounds may occur during use - this is
normal.
1. Always unplug appliance before cleaning.
2. Hand wash in warm, soapy water. Rinse and dry thoroughly. CAUTION: Be
extremely careful of shaving blade in bowl as blade is very sharp. Note: Do not
wash parts in a dishwasher.
3. Clean exterior of the appliance with a damp, soft cloth and wipe dry. Note: Do
not immerse shaver motor in water or other liquid.
4. The collar can be stored in the shaver motor between uses. Remove the collar
from the base by squeezing the tabs and lifting up. Take note of the plastic ribs on
the outside of the collar. Match them up with the gaps in the shaver motor and
slide in.
NEVER ATTEMPT TO SHARPEN SHAVING BLADE AS INJURY MAY OCCUR.
• Frozen carbonated is easier to shave than regular frozen water.
• Do not use ice that has come directly out of the freezer. We advise letting your ice
sit out on your counter to "sweat" for a few minutes or running it briefly under cool
water. This will soften the ice, which makes it easier to shave, produces fluffier
"snow," and will prevent damage to your shaving blade.
U
SING
C
LEANING
This appliance has no user serviceable parts.
H
ELPFUL
Y I S
OUR CE HAVER
Y I S
OUR CE
H
INTS
4
HAVER