Back to Basics Dual Ice Shaver Instruction Manual page 4

7. Add ice cubes to auger.
8. Plug the Ice Shaver into a 120-volt, AC electric outlet only.
9. Place the lid on top of the exterior bowl. Turn the lid counter-clockwise until the
large extended lid tab engages the interlock switch. The motor will start and the
ice will begin shaving.
10. To stop shaving ice, turn the lid clockwise to disengage the motor switch.
11. To dispense syrup, turn the pump spouts outward, away from the appliance.
Place snow cone cup filled with shaved ice under the syrup dispenser spout and
press down approximately 5 to 7 times. Note: The number of pumps depends
on the amount of ice being used and the sweetness desired.
12. Turn the pump spouts toward the front of the appliance to secure. Note: Syrup
bottles may be removed from the ice shaver and stored separately in the
refrigerator beween uses.
13. Unplug from power supply immediately after use. Note: There will always be a
small amount of ice remaining in the exterior bowl after shaving. Discard the
remaining ice.
CAUTION: Do not run ice shaver continuously for longer than 5 minutes as
overheating may occur. Allow motor to cool down before repeat usage.
4