Table of Contents
Advertisement
INSERTING AND REMOVING CASSETTES
- 16 -
NOTES:
• If the erase prevention tab on the cassette is removed, the "TAPE" indication in the viewfinder flashes for
several seconds and the camcorder will not enter record/pause mode.
• See page 8 for "EYEPIECE ADJUSTMENT".
4. Now, press "REC/PAUSE" to start shooting the picture. The "REC" indication appears in the viewfinder and
you are now recording the picture you see through the viewfinder.
5. Press "REC/PAUSE" to stop recording. Press the button again to resume recording. The " " indication will
appear in the viewfinder instead of "REC" while the camcorder is in the record/pause (stand-by) mode.
NOTES:
• The "TAPE END" indication starts flashing in the viewfinder when there is about five minutes recording time
left on the cassette.
• If the record/pause mode continues for more than 5 minutes, the camcorder's power is automatically turned off.
To turn on again, press "REC/PAUSE". The camcorder enters record/ pause (stand-by) mode.
6. Slide "CAM/OFF/VIDEO" to "OFF" position to turn off the camcorder.
7. Press "STOP/EJECT" to remove the cassette.
8. Always remove the power source from the camcorder after use.
NOTE: If you have a cassette tape that has already been partially recorded on and you want to record the
remaining blank section, see "QUICK EDIT" on page 27.
INSTANT REVIEW
1. In record/pause (stand-by) mode, tap "REW/ REVIEW", and the last few seconds of the recorded scene is
Advertisement
Table of Contents
