Table of Contents
Advertisement
Advanced Techniques
7. Complete the title by repeating steps 5 and 6.
8. When you complete your title, press PLAY to create a second title as required,
or press the TITLE ON/OFF button on the remote control to store the title in
memory and remove the title graphics from the viewfinder.
Note: As long as the correct current time can be displayed, the title is held in
memory.
Correcting Errors
1. Press the TITLE ON/OFF button on the remote control.
2. Select the title with the PLAY button.
3. Use the STOP button to select the character to be corrected.
4. Use the F.FWD and REW buttons to correct the character.
5. Press the TITLE ON/OFF button on the remote control to store the
corrected title in memory.
Recording Title on a Tape in the Camcorder
1. Hold down the red button on the CAM/OFF/VIDEO switch while sliding
the switch to CAM.
2. Locate the point of the tape where you wish to record the title ("Using
Quick Edit," p.46).
3. Press the TITLE ON/OFF button on the remote control.
4. Use the PLAY button to select the title you wish to record.
5. Press the Start/Stop button to start recording the title.
6. Press the TITLE ON/OFF button on the remote control to stop recording
the title. The title graphics disappear from the viewfinder and the
camcorder can record normally.
Note: Create and store your title before an event you plan to record. Just
press the TITLE ON/OFF button on the remote control to superimpose the
title over the scene as you record it. This method avoids erasing previously
recorded material which will happen when you record a title on a previously
recorded tape.
Note: Title recording is disabled when you connect the optional AV input
cable to the AV IN/OUT jack to record video and audio from the television or
VCR.
Recording a Created Title while Transferring a Tape
1. Connect the camcorder to the VCR (p.37).
2. Press the TITLE ON/OFF button on the remote control to turn title on.
3. Use the PLAY button to select a title from memory.
4. Press the TITLE ON/OFF button on the remote control to turn title off.
5. Turn on the VCR and set it to record. Hold down the red button on the
CAM/OFF/VIDEO switch while sliding the switch to VIDEO. Press PLAY
on the camcorder.
6. Press the TITLE ON/OFF button on the remote control at the point on
the tape where you wish to record the title.
7. Press the TITLE ON/OFF button on the remote control again to stop
recording the title.
Note: Recording the title during tape transfer will erase a portion of your
50
Advertisement
Table of Contents
