Advertisement
BU-350™
Filling the Tank Reservoir:
1. Place the BU-350™ on a fl at level surface.
2. Loosen the four thumb screws on the sides of the unit.
3. Pull the BU-350™ straight up by the hanging bracket. This will
expose the reservoir compartment.
4. Pull the black reservoir forward to remove it from the compartment.
5. Using premium American DJ
reservoir. Be sure not to over fi ll the reservoir to avoid spilling.
6. Once the reservoir has been fi lled, push the reservoir back into
the compartment. Collapse the unit housing and tighten the thumb
screws.
Operation:
Once the reservoir has been fi lled. You may place the unit on fl at level
surface or hang the unit in a level position. Flip the power switch to on
position and watch the bubbles come out by the hundreds. Be sure
the unit remains in a level position to avoid accidental leaking. Use
the directional fl ap located on the exhaust section to control bubble
spread.
Remote Operation (Optional):
The unit may be used with an optional
may be used to control an output interval and duration. Always be sure
to connect the remote to the 1/4" jack on the rear of the unit prior to
applying main power.
Remote Operation:
1. Plug the remote control into the unit.
2. Flip the main power switch on the unit to the "ON" position.
3. Push the power button on the remote to the "ON" position, main
power will be indicated by a glowing red LED above the remote
power button.
4. For a constant steady stream of bubbles press the "CON-
STANT" button in, an amber LED will glow indicating the unit is
in constant output mode. OR press the "TIMER" button for timer
operation, a green LED will glow indicating the unit is in timer
mode.
5. For timer mode operation see the next section.
American DJ Supply
- www.americandj.com - BU-350™ Instruction Manual Page 5
©
®
Operation
brand bubble juice, fi ll the fl uid
®
optional
optional detachable timer remote that
optional detachable timer remote that
BU-350™
Time Knob - This knob is
used the control the time inter-
val between blast when the
unit is in "TIMER" mode. The
time interval can be adjusted
to range from 3 seconds to 1
minute. Turning the knob in a
clockwise direction will increase
the interval.
Power Button - When the
remote is connected to the
unit, this button will control
the unit's main power. When
the unit is powered, a red
LED above the this button
will glow.
Timer Button - This button
activates timer mode. When
this mode is activated a green
LED above the this button
will glow. Use the "TIME" and
"DURATION" knobs to adjust
the timer settings.
American DJ Supply
- www.americandj.com - BU-350™ Instruction Manual Page 6
©
®
Optional Timer Remote
Duration Knob - This knob
is used the control the blast
duration when the unit is in
"TIMER" mode. The blast
duration can range from 3 sec-
onds to 1.5 minutes. Turning
the knob in clockwise direction
will increase the duration.
Constant
Button
-
button is used to activate
constant mode. When this
mode is activated the unit will
continually produce bubbles
until the unit is turned off or
the reservoir is emptied.
This
Advertisement
