Table of Contents
Advertisement
Built.in
Video
Flash
(for DZ.HS303A
only)
I
When recording photos in a dark place, or if the subject is lit from rear, the DZ-HS303A
makes use of
the builtqn Video Flash for automatic brightening:
The Video Flash can also be set to On where the
light is always being emitted, or Off when you wish to record without using the flash even in a dark
)lace.
Auto
._-when the PHOTO/SELECT
button
Automatically
emits light in dark place or in a spot lit
is pressed
from rear.
On
._.
Always emits light regardless
of brightness.
Off
"_...
No light emission.
1 Press the MENU button,
and choose "Flash"
from the "Camera
Functions
Setup" nrenu.
2 Choose tire option for "Flash"
and decide it.
3 Press the MENU
button to end the
setting.
* Displayed
when
using DZ-HS303A
to record photo
(not displayed
when the optional
Video Flash is
connected).
eOptional
Video Flash (for DZ-
HS303A only)
See "Introductien
to Optional
Accessories"
on
page
138.
You can use the optional
DZ-FLH3
Video Flash*
(p. 138): Refer to the instruction
manual
of Video
Flash for use.
* Unavailable
for DZ-HS300A.
Note:
• The built-in Video Flash setting will not change
even
when the DVD video camera/recorder
is turned off.
Unless recording is to be made with the fixed Flash
setting, it is recommended
to return it to "Auto" after
recording with the "On" or "Off" setting, before turning
the DVD video camera/recorder
off.
• When recording dark subjects
the shutter speed will
be slower, so don't let the camera shake.
• However, dark subjects may not be in clear focus
even if the Video Flash is used. It is recommended
that you light a subject when recording in a dark
place.
• The Video Flash built into DZ-HS303A
cannot be
used when a conversion
lens is attached:
Specify
"Flash: Off"
• The distance for the built-in Video Flash to adjust the
appropriate
amount of light will vary depending
on the
subject, but it is approximately
3.2 - 8.2 feet (1 -
2.5 m).
• The Video Flash automatically
adjusts the amount of
light emitted, but the light amount adjustment
may be
insufficient when a subject is too far away or too near.
• If you continuously
record using the Flash, the Flash
may not emit light or the amount of light may not be
adjustable. After recording using the Flash, it is
recommended
that you wait for a few moments,
before pressing the PHOTO/SELECT
button to
record.
• "f_ " will blink during charging of the battery for Video
Flash.
• While "f_ " is flashing, the video flash will not emit
light, though the DVD camera/recorder
is recording.
• When recording a close-up photo, specify "Flash:
Off". Using the flash too near subject could cause a
whitish image.
• Do not use the Video Flash when approaching
the
human eye. Emitting light from Video Flash near
human eye could damage the subject's eyesight.
Especially when recording a baby or small child,
move the DVD video camera/recorder
at least 3.2 feet
(1 m) away.
• Do not use the Video Flash while pointing it at a driver
in vehicle: Doing so could dazzle the driver, causing
an accident.
• Do not use the Video Flash in a place where there is
flammable
or explosive gas: Doing so could cause fire
or explosion.
• When the DZ-FLH3 optional video flash is attached to
DZ-HS303A,
the built-in video flash in DZ-HS303A
will not operate.
59
Advertisement
Table of Contents
