Complete Conversion - Whirlpool 30" (76.2 CM) FREESTANDING GAS RANGES Installation Instructions Manual

30" (76.2 cm) freestanding gas ranges with standard clean oven
Hide thumbs Also See for 30" (76.2 CM) FREESTANDING GAS RANGES:
Table of Contents

Advertisement

For models with 4 standard burners:
Std burner 88
Std burner 88
For models with 3 standard burners and 1 super burner:
Std burner 88
Super burner 96
5. Place the Natural gas orifice spuds in the parts bag for future
use and keep with the bag containing literature.
6. Reinstall burners, burner caps and burner grates.
To Convert Oven Burner
1. Open the oven door and remove oven racks, oven tray and
flame spreader and set aside.
2. Lift oven burner. The orifice spud is behind the oven burner
air shutter.
A
A. Oven burner
B. Air shutter
14
Std burner 88
Std burner 88
Std burner 88
Std burner 88
B
3. Locate LP gas orifice spud stamped "56" in the package
containing literature supplied with the range.
4. Use a
" combination wrench and remove the Natural gas
orifice spud.
5. Install the number "56" LP gas spud.
IMPORTANT: Do not overtighten.
A
A. LP oven orifice spud stamped with "56"
6. Place Natural gas oven burner spud in plastic parts bag along
with Natural gas cooktop burner spuds for future use and
keep with the package containing literature.
7. Reinstall oven burner.
8. Reinstall oven racks, oven tray and flame spreader.

Complete Conversion

1. Refer to the "Make Gas Connection" section for properly
connecting the range to the gas supply.
2. Turn the manual shutoff valve in the gas supply line to the
open position.
3. Refer to "Check Operation of Cooktop Burners" in the
"Electronic Ignition System" section for proper burner
ignition, operation and burner flame adjustments.
IMPORTANT: You may have to adjust the "LO" setting for
each cooktop burner.
Checking for proper cooktop and oven burner flames is very
important. The small inner cone should have a very distinct
blue flame ¼" to ½" (0.64 cm to 1.3 cm) long. The outer cone
is not as distinct as the inner cone. LP gas flames have a
slightly yellow tip.
4. Close the oven door and turn the knob to "OFF."
5. Refer to the "Complete Installation" section to complete this
procedure.

Advertisement

Table of Contents
loading

Table of Contents