Gsm Transmitter - LG U990 Service Manual

3. TECHNICAL BRIEF

3.2.2 GSM Transmitter

The RTR6275 transmitter outputs(DA_HB2_OUT and DA_LB1_OUT) include on-chip output matching
inductors. 50ohm output impedance is achieved by adding a series capacitor at the output pins. The
capacitor value may be optimized for specific applications and PCB characteristics based on pass-band
symmetry about the band center frequency, the suggested starting value is shown in Figure1.3.
The RTR6275 IC is able to support GSM 900 and GSM 1800/1900 mode transmitting. This design
guideline shows a tri-band GSM application.
Both high-band and low band outputs are followed by resistive pads to ensure that the load Presented
to the outputs remains close to 50ohm. The low-band GSM. Tx path also includes a Tx-band SAW filter
to remove noise-spurious components and noise that would be amplified by the PA and appear in the
GSM Rx band
LGE Internal Use Only
6pF 68Ω
91Ω 91Ω
5pF 51Ω
120Ω 120Ω
[Fig 1.3] GSM Transmitter matching
- 24 -
Copyright © 2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes