Operation - Hitachi C 6DC2 Safety And Instruction Manual

English
4. Regulating the guide (Fig. 12)
The cutting position can be regulated by
moving the guide to the left or right after
loosening its wing-bolt. The guide may
be mounted on either the right or left side
of the tool.

OPERATION

WARNING:
Never touch the moving parts.
Never operate the circular saw with the saw blade turned upward or to the side.
Do not fix and secure the switch lock. Besides, keep your finger off the switch trigger
when the circular saw is being carried around. Otherwise, the main body switch can
be inadvertently turned ON, resulting in unexpected accidents.
Keep the light ON during cutting operation only. If it is lit ON in other cases, the main
body switch can be inadvertently turned ON, resulting in unexpected accidents.
CAUTION:
Don't remove circular saw from workpiece during a cut while the saw blade is
moving.
Pull out the battery after completing operation.
NOTE:
Take care not to lock the motor. If the motor is locked, immediately turn the power off.
If the motor is locked for a while, the motor or battery may be burnt.
1. Operation of switch (switch trigger and light switch)
(1) For safe operation of the machine, a
"switch lock" is provided on the side of a
handle.
If the "switch lock" is pulled in a state
where it is pressed in the direction of the
arrow mark, the
turned ON.
And the "switch lock" is used as the "light
switch". If the "switch lock (light switch)"
is pulled in a state, the light is turned ON.
(2) After the switch is turned ON, even when
you release your hand from the switch
lock, the body continues running and the
light continues being turned ON as long
as you keep on pulling the switch trigger.
20
main switch can be
Guide
Wing-Bolt
Fig. 12
Switch Trigger
Fig. 13
Switch Lock
(Be used as both
Switch Lock and
Light Switch)