Pioneer Aviosys DTV 6010 Operating Instructions Manual page 6

Connectors Names and Functions
Plasma Display Section
The plasma display is provided with 2 video input
connectors, 1 video output connector, audio input/
output jacks and speaker terminals.
There are also CONTROL IN/OUT jacks for
connection of PIONEER components with the SR
mark.
When this video card is installed on a plasma
display, an additional three sets of video input
connectors are provided (total five), together with
one additional video output connector (total two).
See the pages noted in parentheses or the plasma
display' s Operating Instructions for details regarding
connections to the various jacks and connectors.
(1) SPEAKER (R) Terminal
For connection of an external right speaker.
Connect a speaker whose impedance is 8
–16ohms.
(2)CONTROL IN/OUT (monaural mini jacks)
For connection of PIONEER components that bear
the SR mark. Making CONTROL connection
enables control of the plasma display as a
component in a system.
(3) COMBINATION IN/OUT
DO NOT MAKE ANY CONNECTIONS TO
THESE TERMINALS.
These terminal are used in the factory setup.
(4) RS-232C
DO NOT MAKE ANY CONNECTIONS TO
THIS TERMINAL.
This terminal is used in the factory setup.
INPUT3
INPUT4
SCART
AVIOSYS DTV 6010
TV
16 15
14
(5) INPUT1 (mini D-sub 15 pin)
For connection of components that have RGB or
component output jacks such as a personal
computer, DVD player, or external RGB decoder.
Make sure that the connection made corresponds to
the format of the signal output from the connected
component (pages 7 to 10).
(6) OUTPUT (INPUT1) (mini D-sub 15 pin )
Use the OUTPUT (INPUT1) connector to output the
video signal to an external monitor to output the
video signal to an external monitor or other
component.
Note: The video signal will not be output from the
OUTPUT (INPUT1) connector when the main power
of this display is off or in standby mode. (page 10)
(7) INPUT2 (BNC jacks )
For connection of some components that have RGB
or component output jacks such as a personal
computer, DVD player, or external RGB decoder.
Make sure that the connection made corresponds to
the format of the signal output from the connected
component (pages 7 to 9).
8) Synchronizing signal impedance
selector switch
Depending on the connections made at INPUT2, it
may be necessary to set this switch to match the
output impedance of the connected component' s
synchronization signal.
When the output impedance of the component' s
synchronization signal is above 75ohms, set this
switch to the 2.2 k position .
5