Advertisement
Installation and Assembly
BOSCH Monitor Wall Mounts
This product is intended for use with UL
Listed products and must be installed by a
qualified professional installer.
R
Product is UL rated up to ___ TV
sizes, per attached chart
TV size
Model #:
TC9217MM-W
TC9220MM-W
TC9227MM-W
Each monitor mount is for use with a single TV or monitor of a specified size only.
SIDE VIEW
FLOOR
Place TV onto a piece of pipe as
shown. (Pipe should be a few inches
wider than the TV.) Roll TV back and
forth to find the balance point. This is
the center of gravity. Mark the center
of gravity on the side of the TV.
Attach adhesive
pads (X) to top
clamps (Q).
Insert plastic
covers (CC) onto
ends of anti-rollout
hooks (R).
Before you start make sure all parts
shown (see parts list, page 9) are
included with your bracket.
17"
21"
27"
TV
CENTER OF
GRAVITY
Q
X
BOSCH
Models:
IMPORTANT!
carefully study both product instruction sheets
before assembly. The interface bracket
(included with the VCR Mount) must be
attached during monitor mount assembly to
avoid disassembly later.
A
Adjust support tray (A, three
pieces) to match width of TV.
Lock support tray using four
carriage bolts (B), washer/
nut combo (C). Tighten
securely.
CC
R
3 of 12
TC9217MM-W, TC9220MM-W,
TC9227MM-W
IMPORTANT!
Read entire
instruction sheet before you
start installation and assembly.
If attaching a VCR Mount
TV
B
C
ISSUED: 06-25-99 SHEET #: 039-9003-8 02-08-05
Advertisement
