Operating Instructions; Lighting The Heater; Electrical Connection - DeLonghi IH Operating Instructions Manual

Radiant heater

Hide thumbs

page of 6

/ 6
Bookmarks

Lighting the heater

1. Turn on the gas at the gas bottle tap.

2. FROM «G» POSITION, fully depress the control knob for 10 seconds and turn to

(Small Flame) position. (If pilot flame does not ignite return to starting position and

repeat). When the pilot flame is lit, continue to fully depress the knob for a further 20

seconds to allow the thermocouple probe to heat up. Then turn the knob to select the

desired setting as follows:

(Small Flame) Low Input

(Medium Flame) Medium Input,

Auxiliary ignition

Should piezoelectric starter fail to work, repeat operation on control knob and use a match

to light pilot flame and repeat the operations above described.

Tunring off the heater

Turn off the gas bottle tap. The Heater will be totally "OFF" only if the tap at the gas bottle is turned off.

Important

When the large knob is released at the end of the ignition time (see the rating plate and

instruction booklet), it must return upwards by around 5 mm to its initial position. If this does

not happen, close the gas tap and contact your after-sales service centre. Never operate the

appliance with the large knob held downwards by force.

TENSION

220-230V

Electrical connection

Before using the appliance check that your supply voltage is the same as that shown on

the rating label of the unit.

Connect your heater to earth provided socket only, having a capacity of at least 10/16 A.

THIS APPLIANCE CONFORMS TO DIRECTIVE EN 55014 GOVERNING RADIO INTER-

FERENCE.

Operation and use

Fully insert plug into socket-outlet and switch on the fan heater following the instructions of

Fig. 7. Before switching on the gas burner, read carefully the relevant operating instructions.

VENTILATION ONLY

(It can be used together

with the gas burners for

an adequate heat distri-

bution).