Electrical Connection; Installation; Functioning And Use; Cleaning And Maintenance - DeLonghi FAN HEATER Instruction Manual

GB
Voltage/ Wattage

ELECTRICAL CONNECTION

- Before plugging in the heater, check that the voltage of your domestic supply corresponds to the
voltage (V) indicated on the appliance.
- Check that the electrical socket has a rating of 10/16 Amps.
- THIS APPLIANCE COMPLIES WITH EEC DIRECTIVE 89/336, RELATING TO ELECTRO-MAGNE-
TIC COMPATIBILITY.

INSTALLATION

The appliance requires no installation, it should be used solely as a portable appliance.
Portable appliances are not suitable for use in a bathroom.

FUNCTIONING AND USE

Models with function selector and thermostat
Operating the function selector
- Summer use (ventilation only): turn the thermostat dial clockwise to the
- Min power operation: turn the function selector dial to position 1 .
- Max power operation: turn the function selector dial to position 2.
- Switching the appliance off: turn the function selector to position "
the then pull the plug from the electrical outlet.
REGULATING THE THERMOSTAT
When the room has reached the required temperature turn the right thermostat knob
included) in an anti-clockwise direction up to the point where the appliance switches off and not
beyond. The temperature fixed in this way will be automatically regulated and kept at a constant
level by the thermostat.
ANTIFREEZE SERVICE
Turn the left functin selector
When it is set in this way the appliance keeps the room at a temperature of approx. 5° C with mini-
mal energy expenditure.
Models with function selector only
Summer service (ventilation only): turn the function selector
Heating at reduced power: turn the function selector
Heating at full power: turn the function selector
Switching off: turn the function selector

CLEANING AND MAINTENANCE

Before cleaning always remove the plug from the electrical socket.
Clean the air inlet/outlet grilles frequently.
Never use abrasive powders or solvents.
WARNINGS
- Do not use the appliance in the vicinity of showers, bath tubs, wash basins, swimming pools, etc.
- Always use the heater in an upright position.
- Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles (danger of overhea-
ting).
- The heater must be positioned at least 50 cm from furniture or other objects.
- When the appliance is used in portable version, do not place it up against walls, furniture, curtains, etc.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or simi-
larly qualified persons in order to avoid a hazard.
- The appliance must not be positioned directly underneath a fixed power point.
- Do not cover the appliance while it is functioning in order to avoid overheating with the attendant risk of fire.
- Do not use the appliance in rooms less than 4 m
The heater is fitted with a safety device which will switch off the heater in case of accidental overhea-
ting (eg. obstruction of air intake and outlet grilles, motor turning slowly or not at all). To reset, disconnect the
plug from the power for a few minutes, remove the cause of overheating then plug the appliance in again.
Important: never cover this appliance in any manner whatsoever while it is ope-
rating. To do so would cause a dangerous increase in the temperature of the
appliance itself.
to setting 2, then turn the right thermostat knob
1
to setting 0.
1
See rating label
to setting
1
to setting 1.
1
to setting 2.
1
2 in area.
/6 position.
" and the thermostat in
(where
2
to setting
2
.
.