Preparation Before Use; Host Device Connection; Power Connection; Wall Mounting - Detecto Cardinal P50 Owner's Manual

Host Device Connection

Connect the printer to the host device using the supplied RS232 cable.

Power Connection

Insert power adaptor plug into receptacle at rear of printer.

Wall Mounting

A. Drill two appropriate screw holes in the wall, and insert a plastic wall plug in each of the
two holes. Refer to (Fig.1).
B. Fasten the bracket securely to the wall with a screw in each of the two holes. Refer
to (Fig.2).
C. Slide the slot at the bottom of printer to bracket.
Metal Bracket
Align the metal bracket with the holes near the display in the back of the column and install
two (2) M4x12 screws with lock washers to secure the bracket to the column.
Refer to (Fig.3).

PREPARATION BEFORE USE

(Fig.1)
8525-M328-O1 Rev A P50 Owner's
(Fig.2)
(Fig.3)
3