Honda HHT25S Owner's Manual page 6

4. Install cover plate/spacer A onto the output shaft as shown.
COVER
SPACER B
BLADE
Install with the white
markings facing the
debris shield.
BLADE
COVER
COVER PLATE/
SPACER A
5. With the blade cover installed on the blade, install the blade by
aligning the center of the blade with the shoulder on cover plate/
spacer A.
6. Install spacer B, the cover, and the 10 mm lock nut as shown.
Be sure to install the blade with the cutting edges of the saw teeth
in the direction of rotation; the side with the white markings must
face the debris shield.
The output shaft has left-hand threads. Tighten the 10 mm lock nut
counterclockwise.
TORQUE: 14 ft-lb (20 N•m)
7. Remove the 4 mm hex wrench or equivalent from the gear case.
Blade Cover Removal
1. Turn the blade cover slowly until the cover latch is clear of the
debris shield.
Unfasten the latch by lifting the tab off the post.
2. Pull the post end away from the blade and set it on top of the blade
as shown.
POST END
DEBRIS
SHIELD
BLADE
6
TIGHTEN
10 mm LOCK NUT
(left-hand thread)
OUTPUT SHAFT
(left-hand thread)
4 mm HEX TOOL
BLADE COVER
3. Turn the blade cover slowly until the post end is clear of the debris
shield, then remove the blade cover from the blade.
STANDARD ON UKAT TYPES
Blade Cover Installation
1. Install the blade cover over the blade so that half of the blade is
covered.
To prevent the post end from interfering with the debris shield, pull
the post end away from the blade and set it on top of the blade as
shown above.
2. Turn the blade cover slowly until the post end clears the debris
shield.
3. Reposition the post end over the blade.
4. With the blade cover fully seated on the blade, latch the tab over
the post.
Add Engine Oil
The trimmer is shipped WITHOUT OIL in the engine.
Place the trimmer on a level
surface, and then remove
the oil filler cap/dipstick.
A bottle of oil is included in
the box with your trimmer.
Add the entire contents of
the oil bottle into the oil filler
opening.
All Honda engines are run at
the factory prior to
packaging. Most of the oil is
removed prior to shipment;
however, some oil remains in
the engine. The amount of oil left in the engine varies.
If not using the supplied oil, add enough recommended oil
to bring the oil level to the bottom edge of the oil filler hole.
Do not overfill the engine with oil, as the oil tank capacity is small.
NOTICE
Running the engine with too little or too much oil can cause engine
damage. This type of damage is not covered by the DISTRIBUTOR'S
LIMITED WARRANTY (page
Screw in the oil filler cap/dipstick securely.
Please Register Your Trimmer
Please take a few minutes and register your purchase with Honda.
You can register by completing and mailing the registration card on
the back cover of this book or going online to
http://powerequipment.honda.com
Registration.
OIL FILLER
CAP/DIPSTICK
OIL FILLER OPENING
30).
and clicking on Product
(page 16)