SAGEMCOM C120 ECO User Manual page 25

Checking a stored number
If you want to check which number was recorded on the rapid
or
memory key
• From the standby screen, press the memory key that you
want to confirm.
• The number programmed on that key is displayed on the
screen.
Keyboard memory keys
Store a number in memory
• Press then enter the number to be recorded.
• Select the memory key
(2 ~9) you want to program the number on.
After a few seconds, the telephone reverts to the standby
screen: the number is now programmed in the selected
memory key .
Repeat the operation to record a rapid access number on
another key.
To change the number stored on a memory key, save
the new number directly on the memory key in
question.
24
:
then select the keypad key
Mn M1
Calling a stored number
• Pick up the phone; you should hear a dial tone.
• Press the memory button
key (2 ~ 9) on which the number was recorded.
• The phone number is dialled automatically.
OR
• Press . The phone goes into speakerphone mode.
• Leave the handset on its base.
• Press the memory button
key (2 ~ 9) on which the number was recorded.
The phone number is dialled automatically.
Checking a stored number
If you want to check which number was recorded on one of the
memory keys :
• From the standby screen, press the memory key
then press the key (0 or 2- 9) .
• The number programmed on that key is displayed on the
screen.
then hold down the keypad
Mn M1
then hold down the keypad
Mn M1
Mn M1