Samsung LED TV User Manual page 26

Network Connection - Wireless
Connect to the network wirelessly through a wireless IP sharer.
1. Connect the "Samsung Wireless LAN Adapter" into the
The LAN Port on
the Wall
✎
NOTE
x
You must use the "Samsung Wireless LAN Adapter" (WIS09ABGN) to use a wireless network.
x
Samsung's Wireless LAN adapter is sold separately. The WIS09ABGN Wireless LAN adapter is offered by select
retailers, Ecommerce sites and Samsungparts.com.
x
To use a wireless network, your TV must be connected to a wireless IP sharer. If the wireless IP sharer supports
DHCP, your TV can use a DHCP or static IP address to connect to the wireless network.
x
Samsung's Wireless LAN adapter supports IEEE 802.11A, IEEE 802.11B, IEEE 802.11G, IEEE 802.11N. When you play
DLNA video over IEEE 802.11B/G connection, the video may not be played smoothly.
x
Select a channel for the wireless IP sharer that is not currently being used. If the channel set for the wireless IP sharer
is currently being used by another device nearby, this will result in interference and communication failure.
x
If you apply a security system other than the systems listed blow, it will not work with the TV.
x
When applying the security key for the AP (Access Point), only the following is supported.
1) Authentication Mode : OPEN, SHARED, WPAPSK, WPA2PSK
2) Encryption Type : WEP, TKIP, AES
When applying the security key for the Ad-hoc mode, only the following is supported.
1) Authentication Mode : SHARED, WPANONE
2) Encryption Type : WEP, TKIP, AES
x
If your AP supports WPS (Wi-Fi Protected Setup), you can connect to the network via PBC (Push Button
Configuration) or PIN (Personal Identification Number). WPS will automatically configure the SSID and WPA key in
either mode.
x
If the device isn't certified, it may not connect to the TV via the "Samsung Wireless LAN Adapter".
Wireless IP sharer
LAN Cable
USB 1 (HDD) or USB 2 terminal of the TV.
TV Side Panel
or
Samsung Wireless
LAN Adapter
23
English