Table of Contents
Advertisement
Connections
1.
Press down the terminal tab on the back of the speaker.
2.
Insert the black wire into the black terminal (–) and the red wire into the red
terminal (+), and then release the tab.
3.
Connect the connecting plugs to the back of the product by matching the
colors of the speaker plugs to the speaker jacks.
4.
With the product turned off, insert the TX card into the
TX Card Connection (WIRELESS) on the back of the product.
•
Hold the TX card so that the label "WIRELESS" faces upward
and insert the card into the port.
•
The TX card enables communication between the product and
the wireless receiver module.
5.
Connect the left and right surround speakers to the wireless Receiver
module.
6.
Plug the power cord of the wireless Receiver module in the wall
outlet .
✎
NOTE
The surround speakers for HT-C5500 can also be connected to the
Wireless Receiver Module (SWA-5000) if you purchase it separately.
Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is
too close to the product, some sound interruption may be heard due to interference.
If you use a device such as a microwave oven, wireless LAN Card or any other device that uses
the same frequency (2.4/5.8GHz) near the product, some sound interruption may be heard due
to interference.
The transmission distance from the product to the wireless receiver module is about 10m, but may
vary depending on your operating environment. If a steel-concrete wall or metallic wall is between
the product and the wireless receiver module, the system may not operate at all, because the radio
wave cannot penetrate metal.
If the product doesn't make wireless connection, the system needs ID Setting between the
product and wireless receiver module. With the product turned off, press the remote control's
number buttons "0""1""3""5" and turn on the product. With the wireless receiver module
turned on, press "ID SET" button on the back of the wireless receiver module for 5 seconds.
!
CAUTION
Do not insert any other card except the TX card dedicated to the product.
If a different TX card is used, the product may be damaged or the card may not be removed easily.
Do not insert the TX card upside down or in the reverse direction.
Insert the TX card when the product is turned off. Inserting the card when it is turned on may
cause a problem.
If the TX Card is inserted and wireless receiver module setting is complete, sound is not output
from the Surround Speaker connectors on the product.
The wireless receiving antenna is built into the wireless receiver module. Keep it away from water
and moisture.
For optimal listening performance, make sure that the area around the wireless receiver module
location is clear of any obstructions.
If no sound is heard from the wireless surround speakers, switch the mode to DVD 5.1
channel or Dolby Pro Logic II.
In 2-CH mode, no sound will be heard from the wireless surround speakers.
22
English
Black
Red
WIRELESS
TX card
Hide quick links:
Advertisement
Table of Contents
