Jensen VM9726BT Installation Manual
Car media system
Hide thumbs
Also See for VM9726BT:
- Operating instructions manual (140 pages) ,
- Installation manual (4 pages) ,
- Operating instructions manual (235 pages)
Advertisement
What's in the Box
VM9276BT Head Unit
Custom Cosmetic Trim Ring
Hardware Bag
Speaker Output Harness
Power Input Harness
Accessory Harness
Installation Guide
External Microphone
WARNING! Never install this unit where operation and viewing could interfere with
safe driving conditions.
VM9726BT
You will need these tools and supplies to
install your VM9726BT:
• Torx type, flat-head and Philips
screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio (screw
driver, socket wrench set or other
tools)
• Electrical tape
• Crimping tool
• Volt meter/test light
• Crimp connections
• 18 gauge wire for power connections
• 16 – 18 gauge speaker wire
Installation Guide
Tools and Supplies
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Jensen VM9726BT
Summary of Contents for Jensen VM9726BT
- Page 1 What’s in the Box Tools and Supplies VM9276BT Head Unit You will need these tools and supplies to Custom Cosmetic Trim Ring install your VM9726BT: Hardware Bag • Torx type, flat-head and Philips Speaker Output Harness screwdrivers Power Input Harness •...
-
Page 2: Optional Equipment
NOTE: If the VM9726BT is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a short circuit. - Page 3 Installation Using Half-Sleeve Using the Cosmetic Trim Ring TRIM RING A cosmetic trim ring is packaged with the head unit for installation flexibility. This unit will fit into most import dashes with little or no modification to the dash board/cavity. Some MOUNTING SLEEVE US domestic vehicle dashes will accept a Double-DIN chassis,...
- Page 4 128-9184...
Need help?
Do you have a question about the VM9726BT and is the answer not in the manual?
Questions and answers
My unit won't power on, I've checked the vehicle fuses and they are all good. Is there a fuse on, or in the wiring harness itself?
Yes, the Jensen VM9726BT has a fuse in the wiring harness. The troubleshooting section mentions checking and replacing the "radio fuse" and "car battery fuse" if the unit does not power on.
This answer is automatically generated