Alternative Installation - RME Audio AEB4/8-1 User Manual

When using two AEBx-I, the PCI card's word
clock signal will be daisy chained through the
AEBs. For this to work, connect ST7 of the
HDSP 9652 with ST7A of the first AEB. Then
connect ST7B of the first AEB with ST7A of
the second AEB.

6. Alternative Installation

Installation is done comfortably as described using the attached bracket. Alternatively it is pos-
sible to mount the AEB at a different place inside the computer using the supplied nuts. This
requires to drill 4 holes into the housing.
RME does not accept claims for damages of any kind when installing the AEB in this
way! Modifications to the housing should be done by qualified technicians only, and
only after having removed all components from the housing (danger of short circuit
by metal splinter etc).
Remove the bracket from the AEB (2 screws).
1.
Carefully check that the desired location offers a flat plane, is free from any voltage carrying
2.
devices or cables, and that the AEB does not get in contact with other devices even when
the housing is closed.
Please note that the lenght of the supplied cables does not allow any distance to the DIGI
3.
card.
Drill 4 holes, diameter 0.5" (13 mm), distance of 0.75" (19.05 mm) each, at the desired
4.
place (see drill template).
Fit the AEB into the holes and fix it with the supplied nuts.
5.
Connecting an AEBx-I to the second ADAT In of
a HDSP 9652. Remove the jumper ST5, plug
DIGOUT of the AEBx-I on both right and middle
pin of ST5.
User's Guide AEB4/8-I 6