Table of Contents
Advertisement
Setting the Clock
GB
Your system is equipped with a clock which allows you to
turn your system on or off automatically.
You should set the clock:
When you first purchase the mini-compact system
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
1
Switch the system on by pressing STANDBY/ON.
2
Press TIMER/CLOCK twice.
Result: CLOCK is displayed.
3
Press ENTER.
Result: The hour flashes.
4
To...
Turn the MULTI JOG knob to the...
Increase the hours
Right
Decrease the hours
Left
5
When the correct hour is displayed, press ENTER.
Result: The minutes flash.
6
To...
Turn the MULTI JOG knob to the...
Increase the minutes
Right
Decrease the minutes
Left
7
When the correct time is displayed, press ENTER.
Result: The clock starts and is displayed, even when the system is
in standby mode.
You can display the time, even when you are using another
function, by pressing TIMER/CLOCK once.
You can also use
/
buttons on the panel front or
on the remote control to instead of MULTI JOG knob in
/
step 4, 6.
1
4,6
4,6
2
10
Loading and Changing Compact
Discs
The CD disc changer can contain up to three 12 cm or 8 cm
compact discs without using an adapter.
Never force the compact disc carrousel when opening and
closing the compartment.
Never press down or place objects on the carrousel.
Always treat your compact discs with care; refer, if necessary, to
the section entitled "Precautions When Using Compact Discs" on
page 26 .
1
Switch the system on by pressing STANDBY/ON.
2
Press the OPEN/CLOSE(
) button on the front panel.
Result: The compartment opens.
3
Place one or two discs in the front slots of the carrousel, with the
label on the discs facing upwards.
Check that the compact disc has been correctly inserted
in the holder before closing the compartment.
4
If you wish to load a third compact disc, press the DISC CHANGE
button on the front panel (or DISC SKIP on the remote control).
Result: The carrousel rotates by 120°.
5
Close the compartment by pressing the OPEN/CLOSE(
again.
If you wish to start playing a disc directly, you can also
proceed as follows.
To play...
Disc 1
VCD/CD (
Disc 2
Disc 3
Result: The compartment closes automatically and the disc selected
starts playing.
6
To change or unload the compact disc changer, repeat Steps 2 to 5.
Keep the compartment closed whenever you are not
using it, to prevent dust from entering.
5
4,6
1
5
3,5,7
To replay the CD/MP3-CD
This is a player that enables the playback of audio CD, CD-R,
CD-RW , MP3-CD , VCD but does not possess the function that
saves MP3 files.
Do not use CDs of irregular shapes like heart or octagon shapes.
The performance of the player may be degraded.
At least more than one CD should be inserted for playbacks.
1
Press the STANDBY/ON button to switch on the power.
2
Press the VCD/CD(
3
Insert more than one CD or a MP3-CD.
4
Press the VCD/CD(
ton of the remote control.
If there is more than one CD or an MP3-CD inserted,
replays are then processed in order.
Your CD Player will take a few moments to scan through
all the tracks recorded on a particular MP3-CD.
5
Adjust the volume according to needs with the following procedures.
Turn the VOLUME control on the front panel
or
Press the VOLUME + or – button on the remote control.
) button
The volume level can be adjust in 31 steps(VOL MIN,VOL
1- VOL 29,and VOL MAX).
6
If it is desired to stop while the playback is processing, press the
Press...
VCD/CD(
) or Disc 1
Press the VCD/CD(
Disc 2
again.
Disc 3
7
To stop playback, press the
A new disc may be inserted in the remaining two compart-
ments excluding the CD which is being played back.
Press the DISC CHANGER button to open the CD tray.
The revolving part does not turn during playbacks.
If there is not even one CD inserted in the CD tray, it is indicat-
ed as "NO DISC".
4
2,5
1
Selecting a CD in the Disc changer
The CD function is automatically selected when Disc Skip is
pushed.
To select a specific disc, press the corresponding DISC (1, 2, 3) but-
ton on the front panel or DISC SKIP on the remote control, until the
required disc indicator flashes.
Result: All the discs will be played in turn, starting with the one selected.
If you wish to play the current disc only, press CD REPEAT on
the front panel one or more times, until 1 CD is displayed.
) of the main unit to select the CD function.
) button on the front panel or the
but-
) button.
) button once again to playback
button.
2,4,6
5
7
If you use the DISC (1, 2, 3) function when listening to the radio
or to a tape, the system switches automatically to the CD mode.
If the disc selected is not loaded, the next disc is played
automatically.
POWER
OPEN/CLOSE
CD REPEAT
1
2
3
11
GB
Advertisement
Table of Contents
