Table of Contents
Advertisement
4.1 Technical instructions
■
This appliance must be installed and serviced by a qualifi ed technician or
installer.
■
Prior to installation, ensure that the local distribution conditions (nature
of the gas and gas pressure) and the adjustment of the appliance are
compatible.
■
The conditions for this appliance are stated on the label (or data plate).
■
This appliance is not connected to a combustion product evacuation
device. It must be installed and connected in accordance with current
installation regulations. Particular attention must be given to the relevant
ventilation requirements.
■
Before installation, turn off the gas and electricity supply to the appliance.
■
All appliances containing any electrical components must be earthed.
■
The electrical connection and the gas connection must comply with national
and local regulations.
■
The wall socket and plug must be accessible at all times.
■
To create a fi xed connection, ensure that a multi-pole switch with a distance
of 3 mm between the contacts is installed in the supply cable.
■
Make sure the gas pipe and electrical cable are installed in such a way that
they do not touch any parts of the appliance that get hot.
■
In all cases, the main gas valve for the appliance must be easily
accessible.
■
The gas pipe and the connector must not be bent or blocked by any other
appliances.
■
Check the dimensions of the appliance as well as the dimensions of the
gap to be cut in the kitchen unit.
■
The panels located above the work surface, directly next to the appliance,
must be made of non-fl ammable material.
■
A pipe made entirely out of metal must be used behind the oven.
■
Turn on the appliance tap and light each burner. Check for a clear blue
fl ame without yellow tipping. If a burner shows any abnormality, check the
following:
- is the burner head on correctly;
- is the burner base positioned correctly;
- is the burner vertically aligned with the injector nipple.
■
Before using the appliance for the fi rst time, a full operational and leakage
test (using water and washing-up liquid) must be carried out by the fi tter
after installation.
GB 23
Advertisement
Table of Contents
