Craftsman 919.195412 Owner's Manual page 12

5. Rotate each retaining clip clock-
wise and press down until it
snaps into place over the handle.
Retaining Clip
6. If the handle has excessive
movement, it is improperly
installed. Check the following.
A. Are both tabs inside the
handle (Step #3)?
B. Does each clip pass through
both the saddle and handle
(Step #4)?
TO ASSEMBLE WHEELS
It will be necessary
to brace or support
one side of the air compressor when
installing the wheels because the
compressor will have a tendency to
tip.
1. Attach wheels with shoulder bolts
and nuts as shown.
2. Tighten securely. NOTE: The air
compressor will sit level if the
wheels are properly installed.
1000003598
Handle
12- ENG
The wheels and
handle do not
provide adequate clearance, stability
or support for pulling the unit up and
down stairs or steps. The unit must
be lifted, or pushed up a ramp.
ASSEMBLE RUBBER FEET
1. Attach rubber feet with the
screws, washers and nuts pro-
vided as shown in figure below.
2. Tighten securely.
Nut
Flat Washer
Rubber Foot
Screw
OIL FOR PUMP
the pump crankcase. Check oil before
operating air compressor, see Check
Oil under Maintenance.
Nut
Wheel
Shoulder
Bolt
This compressor was
shipped with oil in