separately. IMPORTANT: When using more than one
camera, each camera must be assigned to a speciﬁ c
channel using the channel selection switch located
on the underside of the camera housing.
Select either 1 or 2 for each camera. Each camera
must be assigned to a speciﬁ c channel; both
cameras cannot be on the same channel or the
signals will cancel out. If using only one camera you
can select either Ch 1 or Ch 2; whichever provides the
best picture. The slide switch, located in the battery
compartment of the LCD monitor, must be set to
reﬂ ect the channels in use.
Auto Mode (2 Camera Operation)
To have the LCD Monitor automatically switch
between two active channels, ﬁ rst check the monitor
is set to 1 & 2 position. Next, press the 'A' (Auto)
button on the front panel of the Monitor. The green
LED will light and the Monitor will automatically
switch to a different channel (1 or 2). The monitor will
display images from both cameras alternately.
Portable LCD Monitor
Camera 1 only
Camera 2 only
Camera 1 & 2