Husqvarna LTH2038 Operator's Manual page 7

INSTALL SEAT (See Figs. 3 and 4)
• Remove bolt and flat washer se cur ing seat to cardboard
packing and set aside for as sem bly of seat to tractor.
Remove the cardboard packing and discard.
• Connect switch to seat.
• Place seat on seat pan so all three (3) bottom pads
are positioned over large slotted holes in pan.
SEAT
SWITCH
PAD
SLOT
SEAT
PAN
• Push down on seat to engage pads in slots and pull
seat towards rear of tractor.
• Raise seat and tighten bolt securely.
• Remove tape and discard.
• Lower seat into operating position and sit on seat.
Press clutch/brake pedal all the way down. If operating
position is not comfortable, adjust seat.
TO ADJUST SEAT (See Fig. 4)
• Grasp adjustment handle and pull up, slide seat to
desired po si tion and release adjustment handle.
SLOT
PAD
FLAT
WASHER
SEAT PAN
BOLT
TAB
ASSEMBLY
WIRING HARNESS
Fig. 3
ADJUSTMENT
HANDLE
Fig. 4
TO INSTALL HOOD SCOOP (See Fig. 5)
TAPE
TAPE
7
Fig. 5