Anti-Scalp Rollers; Caster Wheels; Hardware - Husqvarna M-ZT5 Operator's Manual

Anti-scalp Rollers

Anti-scalp rollers keep the deck in the proper position
to help prevent scalping in most terrain conditions. Do
not adjust the rollers to support the deck.
Rollers are properly adjusted when they are just
slightly off of the ground when the deck is at the
desired cutting height in the operating position.
IMPORTANT INFORMATION
Adjust anti-scalp rollers with the mower on a
flat level surface.
The anti-scalp rollers can be set in three positions:
• Upper position 1 to 2½" (25 to 63 mm) grass.
• Middle position 2½" to 4" (63 to 102 mm) grass.
• Lower position 4" to 5" (102 to 127 mm) grass.
The rollers should be approximately ¼" (6.5 mm) from
ground. Do not adjust the rollers to support the deck.
IMPORTANT INFORMATION
To avoid deck damage, the anti-scalp rollers
must not be adjusted to support the deck.

Caster Wheels

Check every 200 hours. Check that wheels rotate
freely.
Removal and Installation
Remove nut and caster bolt. Pull the wheel out of the
fork.
To reInstall, reverse the order. Tighten caster bolt.
If wheels do not rotate freely, take the unit to the dealer
for service.

Hardware

Check daily. Inspect the entire machine for loose or
missing hardware.
MAINTENANCE
Anti-scalp rollers
Caster wheel
8058-054
8058-014
43