Cutting Blades; Blade Replacement - Husqvarna P-ZT26 CE Operator's Manual

Cutting Blades

To attain the best mowing effect, it is important that
blades are well sharpened and not damaged.
Replace blades that have been bent or cracked when
hitting obstacles.
Let the service workshop decide whether a blade
with large nicks can be repaired/ground or must be
replaced. Balance the blades after sharpening.
Check the blade mounts.

Blade Replacement

WARNING!
Blades are sharp. Protect your
hands with gloves and/or wrap
blades with a heavy cloth when
handling.
1. Remove blade bolt by turning counterclockwise.
2. Install new or resharpened blade with stamped
GRASS SIDE facing towards ground/grass
(down) or THIS SIDE UP facing deck and spindle
housing.
3. Install and tighten blade bolt securely.
4. Torque blade bolt to 122 Nm (90 ft-lbs).
IMPORTANT INFORMATION
Special blade bolt is heat treated.
Replace with a Husqvarna bolt if required.
Do not use lower grade hardware than
specified.
42
MAINTENANCE
1. Blade
2. Blade bolt (special)
3. Spindle housing
Blade attachment
IMPORTANT INFORMATION
The sharpening of blades should be carried
out by an authorized service workshop.
2
3
1
8058-013