Hunter Model Type 2 Owners And Installation Manual page 12

7 • Completing Your Installation With a Bowl Light Fixture (Continued)
7-5. To attach the light kit, partially install two
machine screws into the upper switch housing.
7-6. Connect the upper plug connector from the
motor to the lower plug connector in the light kit.
Note: Both plug connectors are polarized and
will only fit together one way. Make sure the
connectors are properly aligned before connecting
them. Incorrect connection could cause improper
operation and damage to the product.
7-7. Align the logo on the upper switch housing with
the notch in the light kit marked with a red dot.
Make sure all the wires from the fan and the light
kit are snug inside the center of the light kit, not
pinched in between the upper switch housing and
the light kit or hanging out of the sides.
7-8. Turn the light kit clockwise until the housing
assembly screws are firmly situated in the narrow
end of the keyhole slots. Install the remaining
screw into the housing. Tighten all three screws
firmly.
Note: In compliance with US federal energy regulations this
ceiling fan contains a device that restricts the light kit to a
maximum of 190 Watts. Exceeding that limit or the marked
limit on this product may result in fire hazard or improper
operation.
Dot
Machine Screw
45034-01 • 10/23/08 • Hunter Fan Company
Plug
Connector
Light
Kit
12
Upper
Switch
Housing
Steps 7-5 – 7-8