Fisher Labs F 75 User Manual page 6

F75
Comprehensive Operating Manual & Guide to Metal Detecting
Assembly
1. Remove all components from box.
2. Attach searchcoil to lower rod by
lining up the holes.
Push coil knob through hole
and tighten knob gently.
You will tighten up the coil knob later.
3. Insert smallest rod into S-rod
(S-rod holds detector body).
Turn top locking collar
counter-clockwise to open up.
Push in pin on small rod.
Slide small rod into upper rod.
Click pin into hole and tighten
locking collar firmly clockwise.
4. Push lower rod into small rod
as follows:
Turn locking collar
counterclockwise to open up.
If plastic insert tab interferes,
push it down, or turn tube upside down.
Push in pin to allow rod to slide in.
Slide lower rod in.
Click pin into any hole.
5. Remove velcro strip from lower rod.
6. Wrap cable around stem as follows:
Leave some slack in cable at
base of lower rod.
Secure cable at base of rod with velcro strip.
Wrap cable loosely around entire
stem up to bent part of upper rod.
You will re-wrap the cable later
after sizing the rods to your height.
6
Battery Compartment
Headphone Jack
Release Clip
2-way
adjustable
armrest
Hand-grip
Menu
Botton
Settings
Switch
Search
Coil Cable
Biaxial Searchoil
On/Off &
Volume
Switch
S-Rod
Dual-function
Trigger switch
Upper
Stem