Airing Your Room
If you wish to provide ventilation, you can use the Fan feature.
1
If necessary, press the
Result:
2
If the FAN speed(F1,F2,F3) indicator is not lit up on the unit:
Press the FAN button on the remote control
or
Press the MODE button on the unit one or more times until the FAN
indicator lights up (F1, F2, F3)
Result:
3
To set the fan speed
Press the HIGH, MED or LOW button on the remote control
it depends of your requirement.
or
Press the Fan speed button on the unit until fan speed appears on the indicator
(F
(F1, F2, F3)
R
Result:
4
To control the direction of the air flow, refer to page 10.
(On/Off) button.
The air conditioner starts up in the mode selected
when the unit was last used.
The unit beeps twice.
The unit beeps each time you press MODE.
The air conditioner starts up in Fan mode.
You can change modes at any time.
When the air conditioner is in Fan mode, the
temperature is not displayed; in this case, you do not
need to set the temperature.
Each time you press a button, the unit beeps.4
Remote Control
Control Panel
E- 9